Shopping List:
Smart thermostat
Thermostat wire

Steps:
1. Start by turning off the service switch at the furnace.
2. Remove the old thermostat.
a. Pull off the front cover.
b. Unscrew the screws inside.
c. Disconnect the wires.
d. Pull off the back cover.
3. Mount the hub in a convenient location near the furnace using a drill and a few screws.
4. Disconnect the wiring from the thermostat to the furnace and run that wiring to the hub. There’s an obvious place on the hub to screw the wires in properly.
5. Run the thermostat wire from the furnace to the hub. The red wire goes to R, the white wire goes to W, and the blue wire (common wire) goes to C.
6. Mount the new thermostat back cover at the location of the old one. This might require drilling for new screws.
7. Using the old two wires, wire the new thermostat and connect it to the back cover.
8. Turn the service switch back on at the furnace.
9. Download the smart app and program it to the thermostat following the manufacturer’s instructions.

Resources:
Richard installed the InvitaTM Wifi Thermostat 564, which is manufactured by Tekmar Controls.



Source link

PAUL WALKER

PAUL WALKER

Lonely traveler, l like to explore with my camera and my laptop every part of the earth.
Close